Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Dot1x port-control auto protocol down (ACS5.3)

Hello everyone! 

I urgently need your help please. 
I would like to configure the ports of a switch for 802.1x. 

when I type the command: Dot1x harbor auto-control on the interface, the protocol is down and users are disconnected wiring. 

Can someone help me please? it is really urgent.

 

thank you in advance

2 REPLIES

Is this the command that you

Is this the command that you are using ?

"Dot1x harbor auto-control"

What else do you have for dot1x on this device?

Rate if Useful :)

Sharing knowledge makes you Immortal.

Regards,

Ed

New Member

hellothank you for your

hello

thank you for your answer.

bellow is the configuration  that i've configured on the switchs:

configure terminal
  aaa new-model
  aaa authentication dot1x default group radius
  !
  interface fastethernet0/1
  dot1x port-control auto
  end


 radius-server host x.x.x.x auth-port 1612 key xxxx

 

but the command : dot1x port-control auto , cause protocol dows but the port status is UP.

I did not understand the function of this command:"Dot1x harbor auto-control" 

could you tell me a little more?

thank you in advance.

 

59
Views
0
Helpful
2
Replies