Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Dot1x problem

HELLO ALL:

We are having some problem with Dot1x.When users connect to Dot1x authentication port, users laptops are not getting authenticated with the server.I am attaching the debug output and running config .

Thanks

2 REPLIES
Silver

Re: Dot1x problem

On interface FastEthernet0/7 Your reauthentication time is set to 7200 seconds which is by default is 3600 seconds.which means that reauthentication will happen every 7200 sec.Your quite mode timing is 5 sec and default is 30 sec.Try using the the default settings for reauth,retransmission and quiet mode timers and check for the issue.Also check for the Dot1x configuration.

refer the following url for the configuration guide:

http://www.cisco.com/en/US/products/sw/secursw/ps2086/products_configuration_example09186a00805e7a18.shtml

Re: Dot1x problem

Add the following to your configuration:

aaa authorization network default group ias-servers

165
Views
1
Helpful
2
Replies