Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Downloading Activex Control

Hi from Barcelona

I'm trying to setup Cisco ACS to use PEAP but before that I need to configure a CA on the server. I'm following the procedure found in http://www.cisco.com/en/US/products/sw/secursw/ps2086/products_configuration_example09186a0080545a29.shtml but I have problems.

When I want to create a Server Certificate, I open the browser from ACS server and type http://localIP/crtsrv/; and when I submit the option 'Submit a certificate request to this CA using a form' , the browser keep thinking with message 'Downloading ActiveX Control'.

This is a W2K Server SP4 and It shouldn't happen. I've tried to install also Microsoft Patch found in Q330389, but it's only for SP3.

Any help

Dani

2 REPLIES

Re: Downloading Activex Control

Try to add the ACS server page to the list of trusted sites. Also make sure download of Active X is set to either Prompt or Allowed/Enabled.

Regards

Farrukh

Re: Downloading Activex Control

Dani,

Try lowering the security level of your browser. This should answer your query,

http://support.microsoft.com/kb/330389

Regards,

~JG

Do rate helpful posts

315
Views
0
Helpful
2
Replies