Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

EAP type not configured

hi

i have an ACS 1113 ....

i have installed and configured the certificate... and trusted the CA certificate... also i configured the global authentication (enable the PEAP ,EAP-TLS)

no when i try to authenticate (by the wireless) i get failed to authenticate

when checking the ACS failed attempts i find the failure code

- EAP type not configured-

i don?t know why its happing....

but every thing is configured...

  • AAA Identity and NAC
3 REPLIES

Re: EAP type not configured

Please make sure on ACS > Network Access Profiles >

Make sure we have "Grant access using global configuration,when no profile matches" option

selected.

Also make sure on ACS > ACS Certificate Setup > Install ACS Certificate >

Make sure a certificate is installed, if it is installed then click cancel.

Also go to ACS > System Configuration > Global Authentication Setup > Make sure under "PEAP" we have checked "Allow EAP-MSCHAPv2" and/or "Allow EAP-GTC" as applicable.

Regards,

~JG

New Member

Re: EAP type not configured

thank you

the "Grant access using global configuration,when no profile matches" option was not selected.

could you please give me a brief of why do we configure the NAP..

Re: EAP type not configured

3835
Views
5
Helpful
3
Replies