Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Hi we setup ISE in our lab. We have 2 PSN registered but one of the node is out of sync after I upgraded form 1.1 to 1.2

Hi we setup ISE in our lab. We have 2 PSN registered but one of the node is out of sync after I upgraded form 1.1 to 1.2

3 REPLIES
Cisco Employee

For out of sync issues, which

For out of sync issues, which most likely are due to time changes or NTP sync issues, you must correct the system time and perform a manual sync up through the UI.

For certificate expiry issues, you must install a valid certificate and perform a manual sync up through the UI.

For a node that has been down for more than six hours, you must restart the node, check for connectivity issues, and perform a manual sync up through the UI.

Could be a certificate issue,

Could be a certificate issue, import and trust the Local cert of that node into the admin node.

Cisco Employee

Is the "sync" button

Is the "sync" button available to you under the "Deployment" tab? If yes then you can check that node and then try to sync it up. If that does not work then you will have to deregister the node and re-register it. 

Hope this helps!

 

Thank you for rating helpful posts!

Thank you for rating helpful posts!
29
Views
0
Helpful
3
Replies
CreatePlease to create content