Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

How do I use ISE to configure switch interface description?

Hi

I am currently explorining all the exiting features of ISE, and was wondering, if it's possible to use an Authorizations Profile, to configure the switch interface description, so that when you run a "show interface status", i would be able to see either wich authorization rule, or pc hostname (dot1x), is currently configured on that port?

I hope someone can help me

Christian Therkelsen

2 REPLIES
Cisco Employee

Re: How do I use ISE to configure switch interface description?

Christian,

I have not had time to test this but potetially you can do this my sending smartport event.

"Auto Smart Port" in authorization results.

M.

How do I use ISE to configure switch interface description?

But wont that require a custom macro per autorization profile, to be manually configured on every switch?

Or can you make a downloadable macro, like with ACL's?

341
Views
0
Helpful
2
Replies