Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

how to add a acs remote agent if I don't visualize the Remote Agents table

Hi!

I would like to configure a remote agent for an AAA test on acs 4.1. I use a software version test installed on a PC with win 2003.

I followed the standard procedure to add a remote agent:

In the navigation bar, click Network Configuration.

The Network Configuration section opens.

If you are using NDGs, click the name of the NDG to which you want to assign the remote agent. Then, in the NDG Remote Agents table, click Add Entry.

The problem is that in "Network Configuration">"name of the NDG to which you want to assign the remote agent",

I haven't any NDG Remote Agents table.

I should enable something in the visualization?

Thanks in advance!

5 REPLIES
Cisco Employee

Re: how to add a acs remote agent if I don't visualize the Remot

Hi,

You can leave the NDG group as "Not Assigned".

Network Device Group can be enabled at Interface Configuartion->Advances Options

Regards,

Vivek

New Member

Re: how to add a acs remote agent if I don't visualize the Remot

I tried to follow your suggestion but the result is the same...

Do you have please other ideas?

Cisco Employee

Re: how to add a acs remote agent if I don't visualize the Remot

Hi,

I guess we need a screenshot showing the problem to help out further.

Regards,

Vivek

New Member

Re: how to add a acs remote agent if I don't visualize the Remot

I resolved the problem with a new ACS device.

Thanks for your suggestion.

New Member

Re: how to add a acs remote agent if I don't visualize the Remot

I have the same problem.

Could you be more specific?

did you reistall acs?

150
Views
0
Helpful
5
Replies
CreatePlease login to create content