Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

How to add RADIUS AV pairs to ACS 3.0 Interface Configuration ?

Hello.

The problem is that under Interface Configuration RADIUS (IETF) AV pairs Primary-DNS-Server (135), and Secondary-DNS-Server (136) didn't displayed.

How to make it visible ?

F.e. for TACACS+ I can add new service, but I don't see any way to do that for RADIUS too.

I found only "example vendor.ini" file under Utils directory, but not sure that it is suitable.

Regards.

1 REPLY
Silver

Re: How to add RADIUS AV pairs to ACS 3.0 Interface Configuratio

Check if the following is the case, if you specify a given AV pair on Cisco Secure ACS, the corresponding AV pair must be implemented in the Cisco IOS software running on the network device. Always take into consideration which AV pairs your Cisco IOS release supports. If Cisco Secure ACS sends an AV pair that the Cisco IOS software does not support, the attribute is not implemented.

141
Views
0
Helpful
1
Replies