Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Bronze

How to get into linux shell on Cisco ISE 1.2 ??

How to get into linux shell on Cisco ISE 1.2 ???

4 REPLIES
Cisco Employee

Please follow the below steps

Please follow the below steps.

Step 1 After the Cisco ISE installation, launch a supported product, such as PuTTY, for establishing a Secure Shell (SSH) connection to a Cisco ISE appliance.

Step 2 In the Host Name (or IP Address) field, enter the hostname (or the IP address in dotted decimal format of the Cisco ISE appliance) and click Open .

Step 3 At the login prompt, enter the CLI-admin username (admin is the default) that you configured during setup and press Enter .

Step 4 At the password prompt, enter the CLI-admin password that you configured during setup (this is user-defined and there is no default) and press Enter .

Cisco Employee

By default the shell is

By default the shell is locked down and you don't have access to it outside of a few "cisco like" commands and some ISE related commands. If you want more than that you will need to install a "root patch" that can be provided by Cisco TAC.

 

Thank you for rating helpful posts!

 

 

Thank you for rating helpful posts!

You cannot!

You cannot!

Cisco Employee

No.  Not unless allowed admin

No.  Not unless allowed admin access and ability to install additional software. 

1760
Views
0
Helpful
4
Replies
CreatePlease to create content