Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

how to re-run setup for ISE Application installation

Hi,

We have recently purchased ISE devices,  i initialized the ise device for the first time and run the Setup wizard.. but while the setup was installing ise application, we had power issue so my ise device got turned off and the ise application was not installed.  now how can i re-run the setup and or how to install ISE-application ?

Please give me the instruction

10 REPLIES
Cisco Employee

how to re-run setup for ISE Application installation

If you are getting console then type Setup command on the console and if not then you have to do the whole installation again. Please follow the instruction given in the below link.

http://www.cisco.com/en/US/docs/security/ise/1.2/installation_guide/ise_ins.html

New Member

how to re-run setup for ISE Application installation

can u tell me How can i get a consol connection to ISE ?   i couldnt find any instruction on this.

Im using cisco ISE 3315

New Member

how to re-run setup for ISE Application installation

sorry i m connected to its consol but i tried typing "setup" but it is not accepting that command

Cisco Employee

how to re-run setup for ISE Application installation

First you have to  log in with admin username and password and then run setup. It would work. see the below link

http://www.cisco.com/en/US/docs/security/ise/1.0/install_guide/ise10_ins.html

New Member

how to re-run setup for ISE Application installation

Dear Ravi,

the above link is only for while you start configuring ISE devices for the First-time.  and im already login through admin user,  but there is no  setup command availble. 

New Member

how to re-run setup for ISE Application installation

anyone knows how to get this issue resolved ???  im totally stuck. I dont have any bootalbe dvd of my ise software to start booting from that dvd. 

any help plz ?

VIP Purple

Re: how to re-run setup for ISE Application installation

Hi Imran,

Can you login int to the device via CLI.

If yes then you can configure what you want on this device.

You can see the status of the ise by issuning : sh application status ise

or paste the output of  sh run:

Please also check this:

http://www.cisco.com/en/US/docs/security/ise/1.0.4/install_guide/ise104_app_f-installing_on_NAC-AC.html

Regards

Sandeep

Cisco Employee

how to re-run setup for ISE Application installation

If you are able to login in to ISE cli then you can configure the steps you missing initially . Check the following link for cli commands

http://www.cisco.com/en/US/docs/security/ise/1.2/cli_ref_guide/ise_cli_app_a.html#wp2096421

New Member

how to re-run setup for ISE Application installation

i have tried all above links, those are all for when u start ise for the first time.

I can normally login to my ise cli and can see the running config,  but while i do   sho app status ise, it says ise is not installed. 

Although this should be very easy to solve but there is no such intruction by cisco . i couldnt find any doc dont know why cisco has not included it

how to re-run setup for ISE Application installation

Imran,

You will have to reimage the appliance to get the setup prompt back. There is no other way to do this.

Thanks,

Tarik Admani
*Please rate helpful posts*

Tarik Admani *Please rate helpful posts*
631
Views
11
Helpful
10
Replies