HTTP Authentication using Tacacs(ACS)

[t.harness]

I am having a problem setting ip http authentication using our ACS 3.2 Tacacs server. I set up the command to tell it to use AAA: ip http authentication aaa. I can use tacacs for telneting in, but on none of my devices I can use http and tacacs? Any thoughts?

[nikhil_m]

Sometimes reinstalling may work

[paul.kyte]

I had the same problem recently but searching on the forum I found the answer

In your ACS server you need to make sure that your user has the following in the TACACS+ section:

tick option "Shell (exec)"

tick option "Privilege level" and put value "15"

Before I did this the I couldnt' log on through the web browser although ACS said I was successfully authenticated. Afterwards I could log on with no problem.

Hope this works for you.