07-31-2013 12:55 PM - edited 03-10-2019 08:42 PM
Hello,
I am going through the steps to enable wired authentication on an ISE installation. I work for a large organization and would like to enable wired auth on just one 48 port switch in order to work out the bugs before implementing wired auth network wide.
When I was at a Global Knowledge ISE seminar we programmed L3 switches for AAA and RADIUS. Can this also be done on an L2 switch? The switch in question is a Cisco Catalyst 3560.
Our L3 switches are Cisco model 4506. If I have to enable AAA and RADIUS on them I would be rolling out ISE for 250 users.
I would prefer to start with one L2 switch with only 24 users.
Any ideas?
Bob
07-31-2013 01:35 PM
Yes, AAA should not require L3 support.
http://www.cisco.com/en/US/docs/switches/lan/catalyst3560/software/release/12.2_55_se/configuration/guide/sw8021x.html
Sent from Cisco Technical Support Android App
07-31-2013 06:33 PM
Hello,
Yes you can also use Cisco Catalyst 3560 to configure AAA and RADIUS. You can configure MAB, DOt1X and CWA.
Please refer to below link which might help you.
08-01-2013 05:45 PM
Yes, you can surely enable AAA and RADIUS on a L2 Switch and for your convenience, you may refer to the following link as well.
http://www.cisco.com/en/US/products/ps11640/products_configuration_example09186a0080ba6514.shtml
It would assist you with your query.
HTH.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: