First check if you have assigned an ip addresss under the user setup | client ip address assignment | specify the static ip address. Also go into Configuration | System | Address Management | Assignment you will see that you have "Use Address Pool" checked. You should also check "Use Address from Authentication Server" This way, since you are authenticating to the "Internal" server it will use the address that you have specified for the client in the concentrator. If there is no address there for the client then it will use the pool.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...