Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ISE 1.1.4 Patch 5 - Release Notes

Any word on the availability of the release notes for ISE 1.1.4 Patch 5?  I have a production affecting bug that is supposed to resolved in a future release and I'd like to know if it is resolved in Patch 5.

Also, in what case would you release a patch and not update the release notes?  This isn't a chicken vs egg argument, there is a patch therefore there should be release notes prior to the patch ever being released.  It's a bit of an oversight IMO.

Everyone's tags (2)
4 REPLIES

ISE 1.1.4 Patch 5 - Release Notes

FYI, ISE 1.2 has been released. My recomandations to upgrade it:

Release Notes for Cisco Identity Services Engine, Release 1.2

http://www.cisco.com/en/US/docs/security/ise/1.2/release_notes/ise12_rn.html

Cisco Identity Services Engine User Guide, Release 1.2

http://www.cisco.com/en/US/docs/security/ise/1.2/user_guide/ise_user_guide.html

Cisco Employee

Re: ISE 1.1.4 Patch 5 - Release Notes

As ISE 1.2 is released you can upgrade to same. For upgrade procedure please follow the attached PDF.

New Member

Re: ISE 1.1.4 Patch 5 - Release Notes

The correct answer is here, in the updated release notes:

http://www.cisco.com/en/US/docs/security/ise/1.1.1/release_notes/ise111_rn.html

My ISE environment is in Higher Education, meaning we can't upgrade to 1.2 until after the fall semester.  That is a December/January project.

Cisco Employee

ISE 1.1.4 Patch 5 - Release Notes

Hi

You can install patches on ISE servers in your deployment from the primary administration node. ISE patches are usually cumulative, however, any restrictions on the patch installation will be described in the README file that will be included with the patch. Cisco ISE allows you to perform patch installation and rollback from either the command-line interface (CLI) or GUI. When you install or roll back a patch from a standalone or primary administration node, ISE restarts the application. You might have to wait for a few minutes before you can log back in.

For more information regarding installation and configuration please go through the following link:

http://www.cisco.com/en/US/docs/security/ise/1.1.1/user_guide/ise_ug.pdf

413
Views
5
Helpful
4
Replies
CreatePlease to create content