Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

ISE after power off !!

Hi everyone,

I have ISE VMWare based. Every time, when I switch the power of the server off for any reason, and turn it on again, I lose the connectivity through HTTP to the ISE but I can still ping it !!!!

I couldn't know what was the issue and for this, I re-installed the whole image again and the problem was solved but now I am facing the same problem since the server was turned off

Plz Help Me

Regards,

1 REPLY
Cisco Employee

ISE after power off !!

What version are you running?

Have you checked the VMware settings against the recommendations for memory/HD/CPU/etc?

Have you checked that the VM is set to bridge mode?

I've been runnint 1.0.4 in my lab for 4 months and have had it shut it down (improperly, due to power interuptions) and I haven't seen this problem.

332
Views
0
Helpful
1
Replies
CreatePlease to create content