I am trying to add a compound condition that points to an internal identity group in an authoirization profile. Something like the rule below.However the rule never gets applied for users in the IT identity group. It moves to the next rule down and applies permissions based off another rule specific for just the device type. If I change the rule conditions to use the identity group instead of the device type it works. However, I want to limit the rule to device type and Identity group. Any ideas would be appreciated.
Rule Name: test Conditions: Android and IT (Expression: InternalUser:IdentityGroup EQUALS IT) then PermitAccess
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...