08-31-2012 02:05 AM - edited 03-10-2019 07:29 PM
08-31-2012 02:22 AM
Why do you want to do that? Perhaps there is a better solution for your problem.
--
Don't stop after you've improved your network! Improve the world by lending money to the working poor:
http://www.kiva.org/invitedby/karsteni
08-31-2012 03:25 AM
I want to test that if the user is on the different IP group then she can access via the same ip pattern. That's it.
08-31-2012 01:30 PM
Hi,
This is not supported. The other NICs are to be used as a probe, of if you are deploying an inline posture node, then nic 1 and nic 2 are used for the untrusted and trusted interface.
Thanks,
Tarik Admani
*Please rate helpful posts*
09-02-2012 12:55 AM
There can be up to 4 NICs defined on ISE
In ISE 1.1.1 the management interface can be accessed only on Eth0. However, ISE will listen on all defined NICs for RADIUS requests
I am not sure of the answer to your question on the default gateway and will check this out
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: