Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

ISE Ethernet NICs

Hi,

Can we seperate each NIC into different networks ?

For example,

NIC1: 10.10.10.x

NIC2: 192.168.10.x

I see that we can configure ip default gateway only for 1 address.

Thanks,

Cat

Everyone's tags (4)
4 REPLIES
VIP Purple

ISE Ethernet NICs

Why do you want to do that? Perhaps there is a better solution for your problem.

-- 
Don't stop after you've improved your network! Improve the world by lending money to the working poor:
http://www.kiva.org/invitedby/karsteni

Community Member

ISE Ethernet NICs

I want to test that if the user is on the different IP group then she can access via the same ip pattern. That's it.

ISE Ethernet NICs

Hi,

This is not supported. The other NICs are to be used as a probe, of if you are deploying an inline posture node, then nic 1 and nic 2 are used for the untrusted and trusted interface.

Thanks,

Tarik Admani
*Please rate helpful posts*

Tarik Admani *Please rate helpful posts*
Gold

ISE Ethernet NICs

There can be up to 4 NICs defined on ISE

In ISE 1.1.1 the management interface can be accessed only on Eth0. However, ISE will listen on all defined NICs for RADIUS requests

I am not sure of the answer to your question on the default gateway and will check this out

398
Views
0
Helpful
4
Replies
CreatePlease to create content