Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ISE - Inline Posture Node Deployment Issue - User can not access network after pass authentication checking

Hi Experts,

I have recently deployed a ISE iPEP in front of a Aruba WLC in bridge mode. After user pass authentication on Aruba WLC, I can see from Monitoring node that the employee role have been granted to the userand a "permit any any acl" has been pushed to IPN. However, user still can not have any network access. When I issue command :" show pep table accesslist normal" and " show pep table session" on IPN but it show nothing. Did anyone have experience the same issue? or any solution or recommended troubleshooting steps?

 

 

Regards,

Eric

 

1 REPLY

http://community

http://community.arubanetworks.com/t5/Controller-Based-WLANs/Does-Aruba-Controller-support-switching-vlan-using-COA/ta-p/194579

119
Views
0
Helpful
1
Replies
CreatePlease login to create content