Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

ISE Live Authentications

I have ISE with latest version 1.2.1.198

I never see any entries in the live authentications page even though I have clients successfully authenticating and being authorised.

Different browsers seem to make no difference.

Has anyone also seen this and has anyone found a bug relating to this?

 

Regards

Roger

 

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

make sure your NAD is

make sure your NAD is configured correctly . and try

ms-ise-mgm01/admin# app config ise

Selection ISE configuration option
[1]Reset Active Directory settings to defaults
[2]Display Active Directory settings
[3]Configure Active Directory settings
[4]Restart/Apply Active Directory settings
[5]Clear Active Directory Trusts Cache and restart/apply Active Directory settings
[6]Enable/Disable ERS API
[7]Reset M&T Session Database
[8]Rebuild M&T Unusable Indexes
[9]Purge M&T Operational Data
[10]Reset M&T Database
[11]Refresh M&T Database Statistics
[12]Display Profiler Statistics
[13]Exit

try

7 to reset the session db
10 to reset the M&T database

Once you have run these commands the DashBoard should begin to display information.

 

4 REPLIES
Cisco Employee

Silly question but do you

Silly question but do you have the ISE servers configured as "accounting" servers in your NADs?

 

Thank you for rating helpful posts!

Thank you for rating helpful posts!
New Member

Yes I have the ISE Servers

Yes I have the ISE Servers configured as accounting servers.

Cisco Employee

make sure your NAD is

make sure your NAD is configured correctly . and try

ms-ise-mgm01/admin# app config ise

Selection ISE configuration option
[1]Reset Active Directory settings to defaults
[2]Display Active Directory settings
[3]Configure Active Directory settings
[4]Restart/Apply Active Directory settings
[5]Clear Active Directory Trusts Cache and restart/apply Active Directory settings
[6]Enable/Disable ERS API
[7]Reset M&T Session Database
[8]Rebuild M&T Unusable Indexes
[9]Purge M&T Operational Data
[10]Reset M&T Database
[11]Refresh M&T Database Statistics
[12]Display Profiler Statistics
[13]Exit

try

7 to reset the session db
10 to reset the M&T database

Once you have run these commands the DashBoard should begin to display information.

 

New Member

This did the trick.Thanks

This did the trick.

Thanks very much for the pointer.

153
Views
5
Helpful
4
Replies
CreatePlease to create content