Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

ISE on SP300-24P Switch

Hi All,

Been tasked with configuring a Cisco SP300-24P Switch to comply with ISE.

We currently have ISE running on Cat Switches no issues, my question is regarding is ISE supported on the SP300-24P.

I can see that the command aaa new model is not supported, aaa group server not supported.

aaa new model

aaa group server

mac address-table notification change

mac address-table notification mac-move

Port commands not supported

authentication event fail action next-method

authentication event server dead action reinitialize vlan 2

authentication event server dead action authorize voice

authentication event server alive action reinitialize

authentication host-mode multi-auth

authentication open

authentication order dot1x mab

authentication priority dot1x mab

authentication port-control auto

authentication periodic

authentication timer reauthenticate server

authentication violation restrict   dot1x pae authenticator

was wondering if anyone has a sample config for ISE config on this model switch                  

1 REPLY

ISE on SP300-24P Switch

I have gone threw the configuration guide of SF 300 series switch and found that this supports 802.1x authentation. So I believe its support ISE also. But you are right aaa new model command is not supported in this. Did you tried without this command?

config guide:

http://www.videosec.com/Cisco-support/SF300-administartion-guide-en.pdf

195
Views
3
Helpful
1
Replies
CreatePlease to create content