Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ise posture status notapplicable

Hello ,

         after upgrading ISE 1.2 to 1.2.1 , I can't see posture status (pending) although it is working properly. I tried to install patch 1 but the same result.

before upgrading , posture status was Pending when posture status still not reach to ISE.

Everyone's tags (1)
7 REPLIES
New Member

Any help please , I think it

Any help please , I think it may be a bug?
 

New Member

I have same problem too. When

I have same problem too.

 

When workstation install NacAgent 4.9.4.3 successfully, then the posture will be stucked.

 

I didn't see about NAC Agent on report: "Posture Detailed Assessment" and "Client Provisioning"

 

Any help or advice please ? Should I configure the redirect ACL, dACL, switch ACL, or something like that ?

 

 

 

 

Cisco Employee

NAC Agent 4.9.4.3 takes a

NAC Agent 4.9.4.3 takes a very long time to complete posture
CSCuq52821

Symptom:
NAC Agent 4.9.4.3 takes about an hour to complete posture

Conditions:
using NAC Agent 4.9.4.3

Workaround:
use NAC Agent 4.9.0.51

New Member

The posture is working fine ,

The posture is working fine , but i can't see the "Pending" status in posture status (attached).

it was working before (1.2 patch 5 ) upgrading to 1.2.1 patch1.

This could be bug

This could be bug

New Member

I am facing the exact same

I am facing the exact same issue with the latest 1.2.1 patch 2,

Does anybody have any confirmed Bug covering this issue ?

 

 

New Member

Thanks , Resolved in 1.3 :)

Thanks , Resolved in 1.3 :)

377
Views
0
Helpful
7
Replies
CreatePlease to create content