I'm authenticating a few Cisco Phones towards ISE via EAP-TLS, and all was working on version version 1.1.
Now that we've upgraded to 1.1.1, I've reimported Cisco's Manufacturing CA and Root CA certificates into ISE, and marked them for trust for EAP-TLS authentications, but when phones authenticate I keep getting the message that they've presented an unknown CA certificate in their certificate request, and obviously we are failing EAP-TLS, but I'm pretty sure the certificates are well imported into ISE, so they should pass the validation.
Is anybody aware of a bug of some sort with this?
I read a post where somebody stated that now ISE would only support one certificate for EAP-TLS auth...
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...