Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

LANLITE in Dot1x monitor mode?

Does LANLITE switches support monitor mode? We can't seem to write the authentication open command under the interfaces.

 

 

Everyone's tags (3)
1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

At a min you need "LAN Base"

At a min you need "LAN Base" to run that feature. You can check Cisco's "Feature Navigator" to confirm this and any similar queries in the future. I wasn't sure so that is what I used to find out :)

I also found this thread helpful:

https://supportforums.cisco.com/discussion/11078736/lan-lite-image-vs-lan-base-image

 

Thank you for rating helpful posts!

Thank you for rating helpful posts!
3 REPLIES
Cisco Employee

At a min you need "LAN Base"

At a min you need "LAN Base" to run that feature. You can check Cisco's "Feature Navigator" to confirm this and any similar queries in the future. I wasn't sure so that is what I used to find out :)

I also found this thread helpful:

https://supportforums.cisco.com/discussion/11078736/lan-lite-image-vs-lan-base-image

 

Thank you for rating helpful posts!

Thank you for rating helpful posts!
Cisco Employee

FYI.. LAN lite is not

FYI.. LAN lite is not recommended with ISE 1.2  (if you are planning for one)

New Member

good function!! thanks for

good function!! thanks for all respondent!

63
Views
0
Helpful
3
Replies
CreatePlease to create content