Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Linux RADIUS authentication via ACS

I am trying to authenticate my linux users thru RADIUS via Secure ACS 3.3. Local login to linux works fine, but when a user trys to connect via SSH or Telnet, the login fails. The failed attempts log shows "User Access Filtered", the RDS.log shows "User may not connect with present CLI". Any ideas?

1 REPLY
New Member

Re: Linux RADIUS authentication via ACS

I got it to work. I had to uncheck the "Per Group Defined Network Access Restrictions" under Network Access Restrictions in the groups setup. I don't know why this is necesary though. For this group, all of the network groups were accessible on any port from any IP.

997
Views
0
Helpful
1
Replies
CreatePlease to create content