Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Linux upgrade in guest NAC 3315

Hi all,

IS there an option to upgrade the pre installed linux OS in the NAC to latest ?

Thanks,

Regards,

Vijay.

1 ACCEPTED SOLUTION

Accepted Solutions

Linux upgrade in guest NAC 3315

Hi,

You do not have that option the Cisco NAC product line comes with a linux version that is customized for the solution.

Thanks,

Tarik Admani
*Please rate helpful posts*

Tarik Admani *Please rate helpful posts*
4 REPLIES

Linux upgrade in guest NAC 3315

Hi,

You do not have that option the Cisco NAC product line comes with a linux version that is customized for the solution.

Thanks,

Tarik Admani
*Please rate helpful posts*

Tarik Admani *Please rate helpful posts*
Community Member

Linux upgrade in guest NAC 3315

Thanks a lot Tari for the clarification . If there any issue related with linux then should we need to change the entire box ?

Regards,

Vijay.

Linux upgrade in guest NAC 3315

I would be curious as to which issues you are experiencing with Linux, keep in mind that the NGS is a Cisco version of linux that runs the NGS. If you are having issues your best bet is to open a tac case or check the release notes for any bugs that match your condition. At times patching the unit will possibly fix the issues you are experiencing.

Thanks,

Tarik Admani
*Please rate helpful posts*

Tarik Admani *Please rate helpful posts*
Community Member

Linux upgrade in guest NAC 3315

Hi Tarik ,

The device was working fine previously. But we got some error message like this ,

Warning: file(/etc/sysconfig/network-scripts/ifcfg-eth0): failed to open stream: No such file or directory in /guest/www/html/PaFramework/common/SimpleConfigFile.class.php on line 89

Afterthat we were not able to reach the device.Hence we rebooted the deivce .But during bootup also we got the same error and same issue persists.

Hence we tried to configure the other ports , and rebooted the device. but sill no luck.

Then we did re-imaging that also didn't helped

So wanted to know before confirming this as hardware issue , whther we can do some R&D at linux level

Thanks,

Regards,

Vijay

205
Views
0
Helpful
4
Replies
CreatePlease to create content