On a 2960 with 12.2(44)SE, I'm trying to have user "zero" connect via ssh and be able to run level 0 commands, plus show commands, minus "enable". After login, I get "% Authorization failed" and am bounced out. User "admin" should connect at level one and must use "enable" to reach level 15.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...