Logging directly into enable mode on a PIX using TACACS
I have setup TACACS authentication on a PIX running 6.3(3). I can authenticate using TACACS just fine, but do not get put directly into enable mode. The ACS server is setup to do so, it works for routers and switches, but not the PIX box. If I put the "aaa authentication enable console TACACS" in the config I must enter the enable command and use the same password I logged in with to get into enable mode. Without the command, I have to use the configured enable secret password to get into the enable mode.
Does anyone know it there is a way to configure the PIX to log someone directly into enable mode via TACACS?
BenefitsDocumentationPrerequisiteImage Download LinksLimitationsSupported PlatformsLicense RequirementsTopologyStep-By-Step ConfigurationConfigure Virtual ServiceActivate the virtual service and configure guest IPsConfiguring UTD (Service Plane)Configurin...
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...