MS-CHAPv2 attribute error in ASA querying AD via ACS 5.2
We have just set up a Secure ACS 5.2 VM to provide authentication for Anyconnect VPN clients. The clients connect to an ASA 5520, which queries the ACS, which in turn queries Active Directory directly. All seemed to work OK, but I noticed it was using PAP. Following some docs, MS-CHAPv2 was enabled via the "Password-management" command. This broke the configuration and the error on the ACS was:
11309 Incorrect RADIUS MS-CHAP v2 attribute
Some references suggest that the ASA and ACS should talk MSCHAPv2 without additional config, so I guess it must be the ASA config for the tunnel-group. There are additional secondary authentication and authorisation pages on ASDM, that I suspect might be necessary to use mschap.
Please comment on this issue - all responses gratefully received!
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...