Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

zhh
New Member

multiple mac and ip-adresses on ACS appliance

Our network is in 172.25.x.x range, we have 2 ACS appliances, with ip-adresses 172.25.30.71 and .72

Our fluke network scanner reports a duplicate ip-address on the switchports where the acs appliances are connected to.

The duplicate ip-address is 192.168.0.1, but we can't find this ip-address anywhere in the ACS. The address is even reachable, I put my pc in the same range .2 and I could ping the ip-address.

Does someone know where to find/delete/change those strange ip-addresses in our ACS? We use software level 4.1 on windows 2000. We only connected 1 interface of the machine, the extra ip-address is on the same interface as the ip-address we use, there are also multiple mac-addresses shown on the switchport.

Thanks

Edwin

13 REPLIES

Re: multiple mac and ip-adresses on ACS appliance

Edwin,

Logon to acs---> Network confiuration----> Search IP ---->192.x.x.x and see if it finds any.

It could be possible that 192 IP is still there from old configuration of acs.

If you can find it, delete it.

Regards,

~JG

zhh
New Member

Re: multiple mac and ip-adresses on ACS appliance

Thanks for your answer, but it doesn't find any 192 IP.

And I think it is not possible that the 192 IP is from an old configuration, we recently recovered both ACS appliances from the boot CD (version 4.1).

Anymore ideas?

Re: multiple mac and ip-adresses on ACS appliance

Hi,

If you bring appliance off the network , can you still ping 192 ip ?

Regards,

~JG

zhh
New Member

Re: multiple mac and ip-adresses on ACS appliance

When I disconnect both appliances from the network, I can't ping them anymore.

Regards,

Edwin

zhh
New Member

Re: multiple mac and ip-adresses on ACS appliance

Any other ideas?? Is it a bug in the ACS? Anyone noticed the same event happening?

Re: multiple mac and ip-adresses on ACS appliance

Check for that mac-address vendor,

http://www.coffer.com/mac_find/?string=00%3A0D%3A65

zhh
New Member

Re: multiple mac and ip-adresses on ACS appliance

The original mac-addresses are 00-16-36-eb-2c-7c and 00-16-36-91-9c-6b

And on the same network interface of both acs appliances the analyzer also finds mac-addresses 00-16-36-eb-30-c9 and 00-16-36-91-a0-fe.

So they are almost similar, but 4 last digits are different. It is strange that I can't find any of it in the config.

Re: multiple mac and ip-adresses on ACS appliance

These mac belongs to Quanta Computer Inc. I would suggest you to open a TAC case.

Also please avoid rating on the troubleshooting conversation, as we all know that these initial conversation is not going to help !

~JG

New Member

Re: multiple mac and ip-adresses on ACS appliance

I found this post while researching. We are working on the same trouble.

Even log shows dupl IP from an unknown MAC

Same ACS version.

New Member

Re: multiple mac and ip-adresses on ACS appliance

We fixed the problem with the ACS sending out duplicate IP's.

Install instructions said to use bottom ethernet interface (NIC1) but we had originally used and configured the top.

We moved the cable to the bottom NIC.

Restarted the unit

Using the serial cable - reprogrammed the IP/mask/gw/DNS etc using the set ip command.

Viola, no more problems :-)

New Member

Re: multiple mac and ip-adresses on ACS appliance

I am having the same issue with two 4.1 appliances. Did you have any luck with resolving this problem?

Seems like a bug, but TAC has not been able to help much. I have applied all the upgrades and pathes for 4.1.

zhh
New Member

Re: multiple mac and ip-adresses on ACS appliance

We have not solved the problem, but we left it as it is for now.

But did you receive an answer on a TAC? But it did not work out?

New Member

Re: multiple mac and ip-adresses on ACS appliance

TAC had no specific solution and hence we went through all the published patches for acs 4.1 release. TAC is going to RMA our appliances. Hopefully we will not have the same problem with the new appliances.

It is puzzling where the IP 192.168.0.1 is coming from. Given that the the interface on the appliance has 2 MAC addresses, it seems that the IP is configured in the underlying windows OS, however the OS part of the appliance is locked out.

206
Views
4
Helpful
13
Replies
CreatePlease to create content