NAC agent dont popup automaticaly at the first connexion
I have ISE 1.2 and catalyst 2960
But the NAC agent is not poping up automatically at the first conection on the network
All log and authentication session look OK but the NAC agent dont popup automatycaly At the first conexion on the network I must right click on NAC properties and enter manualy the IP address of the ISE on the discovery host field before get the NAC popup
Then for the second and the other next conexion on the network, the NAC agent popup automaticaly, even if I remove the IP address of the ISE on the discovery host field
Why do I need to enter the IP of the ISE manualy before get the first NAC agent popup ?
I need the NAC agent to popup automatycaly at the first conexion of the PC on the network (switch) without entered manually the IP address of the ISE on the discovery host field
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...