Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

NAC Agent - Loop in Remediation WSUS

Hello,

 

I´m implementing WSUS Posture in my ISE environment.

When NAC Agent detect a new Windows Update, the Remediation Action is Automatic. I configured Show UI the Wizard Interface and this is working well. 

But, after the windows update instalation, the NAC Agent stay in Remediation Process. Looking for WindowsUpdate.log file, I see repetitive messages like: 

Updates Found = 0 OR Found 0 Updates and X categories in search.

 

If I use the Windows Update from Windows to Search and Install the Updates, work very well too.

 

The image attached, ilustrate my problem(In this point, The Windows Update instalation was done):

 

 

 

  • AAA Identity and NAC
1 REPLY
New Member

Updating..Approximately after

Updating..

Approximately after 30 minutes, NAC Agent finished the process of Remediation. (Only 1 Windows Update package)


apparently the station sends many reports to WSUS and while it does, the NAC Agent continues Remediation on the process, even after installing the update. 


I'm sure there are how to optimize it, but if anyone has any tips I'd appreciate it.

 

Best Regards,

Daniel Stefani

43
Views
0
Helpful
1
Replies
This widget could not be displayed.