Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

NAC Agent on MAC OSX 10.9

Hi,

I found on our setup, NAC Agent for MAC does not run properly on MAC OSX 10.9, even the latest MAC Nac Agent (version 4.9.0.1007)

It does not scan, does not pop up, and the endpoint's posture status is always stucked on pending state.

Does any one experience the same?

When will Cisco support it.

Best Regards,

Tomi

1 REPLY
Cisco Employee

NAC Agent on MAC OSX 10.9

NAC Agent 4.9.0.1013 was posted to CCO yesterday and has support for Mac OS 10.9.

NAC & ISE supports for latest OSes - Windows 8.1 and MAC OSX 10.9

NAC:

NAC Server patch for NAC 4.9.3 release is published on CCO. Refresh NAC and Web Agents are posted on Perfigo  and CCO sites.

Customer may please be advised to apply Server patch, refresh Agents and  update to latest Compliance Module and Support Charts v3.6.7873.2.

ISE:

ISE 1.2 Patch 3 is published on CCO and Refresh Agents are posted onto provisioning-update feed file on perfigo server.

Customer may please be advised to apply Server patch, provision refresh Agents and to do a posture-update get latest Compliance Module and Support Charts v3.6.7873.2.

Please refer respective release notes for open caveats.

Please rate helpful posts and mark as answered if this fixes your issue.

Charles Moreton

560
Views
0
Helpful
1
Replies
CreatePlease to create content