Hi everybody, I'm setting up a NAC Appliance 4.9.4, I configured a High Availabitity between the two CAMs but this is not working correctly. When I disconnect the primary CAM (from Eth0 and Eth1:UDP Heartbeat Port) the secondary CAM doesn't take the role automatically; to move from the standby mode to the Active mode it asks always for a license:
I entered the licenses before in the two CAMs, Is the problem comes from the support of HA of my Licenses ? Should I purchase a HA License?
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...