Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

NAC Manager High Availability Peer CAM DEAD

Hi,

I have two NAC Managers with High Availability and  i have used both sides eth1 interface as a Heartbit link.  

I have done following Steps for High Availability.

1) Synchronize the times between two CAMs.

2) Generate a Temporary SSL certificate in both CAMs and done export-import procedure in each other.

3) Make One CAM as a  Primary and another as Seconday.

 

But after all this configuration done i can see the status in Monitoring> Reports as--------Primary CAM is up in both the servers and Redundant CAM is down.

Also in Failover Tab i can see ------Local CAM - OK [Active] and   Peer CAM :- DEAD.

 

I have also attached some screenshots so you can find out the same.

Your help will highly appreciated.

 

Thanks 

1 ACCEPTED SOLUTION

Accepted Solutions
Gold

Try the following steps and

Try the following steps and verify that all the steps were followed :

http://www.cisco.com/c/en/us/support/docs/security/nac-appliance-clean-access/99945-NAC-CAM-HA.html

1 REPLY
Gold

Try the following steps and

Try the following steps and verify that all the steps were followed :

http://www.cisco.com/c/en/us/support/docs/security/nac-appliance-clean-access/99945-NAC-CAM-HA.html

118
Views
0
Helpful
1
Replies