06-17-2014 03:07 AM - edited 03-10-2019 09:48 PM
Hi,
I have two NAC Managers with High Availability and i have used both sides eth1 interface as a Heartbit link.
I have done following Steps for High Availability.
1) Synchronize the times between two CAMs.
2) Generate a Temporary SSL certificate in both CAMs and done export-import procedure in each other.
3) Make One CAM as a Primary and another as Seconday.
But after all this configuration done i can see the status in Monitoring> Reports as--------Primary CAM is up in both the servers and Redundant CAM is down.
Also in Failover Tab i can see ------Local CAM - OK [Active] and Peer CAM :- DEAD.
I have also attached some screenshots so you can find out the same.
Your help will highly appreciated.
Thanks
Solved! Go to Solution.
06-19-2014 07:59 AM
Try the following steps and verify that all the steps were followed :
http://www.cisco.com/c/en/us/support/docs/security/nac-appliance-clean-access/99945-NAC-CAM-HA.html
06-19-2014 07:59 AM
Try the following steps and verify that all the steps were followed :
http://www.cisco.com/c/en/us/support/docs/security/nac-appliance-clean-access/99945-NAC-CAM-HA.html
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: