Not sure if I missed something in the update/release notes, but my NAC stopped working after I updated the CAS/CAM to 4.9.1. I was on 4.8,0 and it was working fine but now it's not working. Below are some of the things that I am noticing.
- If I set a port to be controlled and plug my PC into the port I am moved to the authentication VLAN and can proceed to the web login where I can download the NAC Agent, and then nothing happens after the agents is installed and in the tray.
- If I right click on the agent I see that "login" is greyed out.
- If I right click on the agent and go to properties the page that comes back has the correct CAM identified.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...