Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

NEAT Network Edge Authentication Topology

Hello,

i´m using ACS5.5. NEAT work fine. Is there a possibility to add a command when the port changes from access to trunk? Because cdp is not enabled when it is an access port. But when it changes to trunk i would like to enable cdp.

Jan 17 11:39:09.922 CET: Applying command... 'no spanning-tree bpduguard enable ' at Gi0/3

Jan 17 11:39:09.938 CET: Applying command... 'no switchport access vlan 998' at Gi0/3

Jan 17 11:39:09.989 CET: Applying command... 'no switchport nonegotiate' at Gi0/3

Jan 17 11:39:09.997 CET: Applying command... 'switchport trunk encapsulation dot1q' at Gi0/3

Jan 17 11:39:10.014 CET: Applying command... 'switchport mode trunk' at Gi0/3

Jan 17 11:39:10.039 CET: Applying command... 'switchport trunk native vlan 998' at Gi0/3

Jan 17 11:39:10.047 CET: Applying command... 'spanning-tree portfast trunk' at Gi0/3

                                                                       cdp enable                                                  <----- that is what i want to add

Horst

1 REPLY
New Member

Im also looking to add some

Im also looking to add some commands to the "template" the ISE pushes to the port.

Maybe a switchport trunk allowed vlan list and such

The implementation i have is a Cisco ISE 1.3.

Did you manage to solve this ?

171
Views
0
Helpful
1
Replies