cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
374
Views
0
Helpful
4
Replies

Need some one help

chaitu_kranthi
Level 1
Level 1

Hi

Iam trying to adding the PIX firewall to my newly installed the ACS server.

after adding all the required commands still i am unable to access the firewall using local user only.

my firewall is already having some aaa commands earlier. and i am unable to clear that lines.

PIX515# sh run | inc tacacs

aaa-server TACACS+ protocol tacacs+

PIX515# sh run | inc aaa

aaa-server TACACS+ protocol tacacs+

aaa-server TACACS+ max-failed-attempts 3

aaa-server TACACS+ deadtime 10

aaa-server RADIUS protocol radius

aaa-server RADIUS max-failed-attempts 3

aaa-server RADIUS deadtime 10

aaa-server LOCAL protocol local

PIX515#

some body please help me how to delete the above commands and what are the command that i have to place.

Pix Version:

Cisco PIX Firewall Version 6.3(4)

4 Replies 4

Hi, these are the commands yo need

aaa-server TACACS+ protocol tacacs+

aaa-server TACACS+ host cisco

aaa authentication http console TACACS+ local

aaa authentication ssh console TACACS+ local

aaa authentication telnet console TACACS+ local

Also create a local admin user =

username admin password admin privilege 15

Now, to delete the old code, if you have not done "write mem" then a reboot will do.

or else you will have to follow the procedure given in this link :

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_password_recovery09186a008009478b.shtml

Hi,

i can able to login to the device using local username & password. i.e. telnet iam able to login.ssh is not allowing me.

now tell me how can remove the previous commands with out rebooting the device.

Hi,

try these

no aaa-server TACACS+ protocol tacacs+

no aaa-server RADIUS protocol radius

still in same position

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: