No TACACS+ Administration Reports after upgrade to ACS 4.1
I was running ACS 4.0 demo version. Everything was running fine.
After upgrading and keeping the old configuration, I can't see logs in the TACACS+ Administration Reports. I kept the configurations on the router and switch the same, so I believe that the problem resides in the ACS software.
I tested some debug, and it seems that the router is sending the command that is being typed to ACS.
Here is the config I?m using:
tacacs-server host 192.168.X.X key XXXXXXXXXXX
aaa authentication login telnet group tacacs+ enable
aaa authentication login console enable
aaa authentication enable default group tacacs+ enable
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...