Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Per user bandwidth rate limit.

                   How to configure per user bandwidth rate limit for wireless guest client, authentication server is ISE 1.2 & wireless controller is 5760.

Cisco Employee

Per user bandwidth rate limit.

There are Advanced Attribute Settings in the Authorization profiles.

There is a bug in WLC code that effectively ignores the AV pairs sent from ISE.

Bug id is CSCsd14297. Should be fixed in 8.0 code.

Will have to wait for that version for now.


Re: Per user bandwidth rate limit.

WLC code 7.3 onwards you can do bi-directional rate limiting chech the guide given below or use third party solution

New Member

Per user bandwidth rate limit.

The Cisco 5760 WLC supports better QoS than other c

ontrollers, allowing prioritization of mission-crit



The Cisco 5760 WLC supports four wireless hardware

queues and priority-based queuing compared to

software-based queuing in existing controllers.

The Cisco 5760 WLC follows MQC based commands, allo

wing usage of exact commands for configuring

QoS on different types of network devices.

The Cisco 5760 WLC supports QoS policies to be appl

ied in a hierarchical fashion with more granularity

per SSID per radio, while on the current controller

s granularity is per WLAN.

The Cisco 5760 WLC supports approximate fair bandwi

dth to make sure of fairness at client, SSID, and

radio levels for Non-Real Time (NRT) traffic. There

fore, if one user consumes excessive bandwidth, we


limit the amount of bandwidth that user receives an

d thereby not deprive other users.