I'm configuring a ACS 1113 and i had a weird problem , i've disabled the CSA to enable pings ok, it works from my PC to ACS but the ACS can't ping my PC !
I'm also having another problem , i can access the ACS and it's all configured but when i put it on the network i can't access it, then i put it direcly connected to my PC i can access the web interface normally.
I don't know what happened.... I saw one post that said that i should configured straight connected to the network... but i did not done it i connected my notebook and made the tests before put up on the network....
Someone knows why ??? and what is the work arround for it????
I've attached the ping information and my Ipconfig from my notebook and a follows the "show" connected thru console
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...