I have a 802.1x solution with two redundant ACS 5.2. Network A configuration use like Primary ACS-SJM and ACS-GLX like a secondary for network B
configuration use like Primary ACS-GLX and ACS-SJM like a secondary. My solution was working fine about one year ago. but one week ago isn´t working fine. The problem my ACS-SJM lost connectión and user can´t authenticated when the user trye to connect to ACS-GLX either can´t connect. I have to shutdown the ACS-SJM that way can authenticate to the ACS-GLX. I check the log and I didn´t find anything I check the switch.. too where the ACS is connected. but didn´t find anything too.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...