'You can use level 0 to specify a subset of commands for specific users or lines. For example, you can allow user "guest" to use only the show users and exit commands.'
There's another passage in the same link that talks about how Level 0 commands don't automatically get allowed for higher levels:
'There are five commands associated with privilege level 0: disable, enable, exit, help, and logout. If you configure AAA authorization for a privilege level greater than 0, these five commands will not be included.'
So maybe that's the issue - that your level 1 user isn't inheriting level 0 command privileges because they don't pass from level 0 to higher levels.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...