"LDAP" over SSL will not work with my IP Access-group in VLan
Hello I have a issue with LDAP using SSL. I am looking for help on this issue or advice or guidance.
I have created a VLAN with inside the corporate network using a Access-group list to allow specific traffic to flow. When I am trying to used any LDAP over SSL I get a deny message. I have permit ip between the host. For example permit ip host 22.214.171.124 host 126.96.36.199.
There are to cisco products one is ironport(port 3269) and other is the asa (port 636) device.
I can get the normal LDAP port to work fine no issue but I would like to used LDAP over SSL.
Specially on the ASA when I setting up AAA server.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...