Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

"The Page Cannot Be Displayed" error when clicking the Remote Agent

Hi everyone! We have installed ACS SE 4.0 and we have added a remote agent running on Windows Server 2003. Recently, we are encountering "The page cannot be displayed" error when we click the RA under a network device group. This is resolved by rebooting the ACS SE appliance and accessing the ACS SE web console again but after few hours, problem reoccurs. Clicking the links on the ACS SE web console is okay at first but after clicking the RA, every link shows the error "The page cannot be displayed." Hope you could help us on this problem. Anyone's support is very much appreciated.

Thanks!

1 ACCEPTED SOLUTION

Accepted Solutions

Re: "The Page Cannot Be Displayed" error when clicking the Remot

Hi Jas,

Here is the bug CSCsg40444.

Regards,

~JG

Do rate helpful posts

4 REPLIES

Re: "The Page Cannot Be Displayed" error when clicking the Remot

Jasper,

This is a known issue with 4.0. I would suggest to upgrade acs and remote agent to ver 4.1.1.

Regards,

~JG

Do rate helpful posts

New Member

Re: "The Page Cannot Be Displayed" error when clicking the Remot

Hi JG,

Thank you so much for your response. Does Cisco have a documentation that states that this is a known issue with 4.0, such as release notes, for we might need this for the proposal upgrade?

Again, thanks a lot!

Re: "The Page Cannot Be Displayed" error when clicking the Remot

Hi Jas,

Here is the bug CSCsg40444.

Regards,

~JG

Do rate helpful posts

New Member

Re: "The Page Cannot Be Displayed" error when clicking the Remot

thank you so much for your very helpful response.

155
Views
0
Helpful
4
Replies
CreatePlease to create content