Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

%RADIUS-3-RADIUS_ERROR_MESSAGE: setsockopt success, Using src-intf: for sock 22. Error: Success

get this message on a nexus 1000v version 4.2(1)SV1(4a)

but radius authentication works

how can I get rid of this message

1 REPLY

%RADIUS-3-RADIUS_ERROR_MESSAGE: setsockopt success, Using src-in

Hi Frank

I have the same problem and also in Nexus 5596.

With following configuration, the event will dissapear:

sw-n1k# conf t

sw-n1k(config)# logging level radius 2

sw-n1k#

2013 Sep 13 13:51:15.190 sw-cpd-n1k-1 %RADIUS-3-RADIUS_ERROR_MESSAGE: setsockopt success, Using src-intf: for sock 30. Error: Success

2013 Sep 13 13:59:01.481 sw-cpd-n1k-1 last message repeated 2 times

2013 Sep 13 13:59:01.481 sw-cpd-n1k-1 %VSHD-5-VSHD_SYSLOG_CONFIG_I: Configured from vty by <...> on x.x.x.x@pts/19

2013 Sep 13 13:59:09.608 sw-cpd-n1k-1 %SYSMGR-STANDBY-5-CFGWRITE_STARTED: Configuration copy started (PID 28395).

sw-n1k#

Regards.

773
Views
0
Helpful
1
Replies