Being Radius a client/server protocol, is there some standard way for the server to send commands to the client? For example, can a Radius server send a "standard" command to a Cisco RAS in order to disconnect some dial-up user?
From your comment, I deduce that the only way to do this, is through "propietary" radius attributes. The need we have is to restrict the access and/or bill for the access time. What steps would we need to follow to build this in the right way?
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...