I am doing 802.1X for a user on Cisco 3650 and wanted the Radius Server to return an attribute to set the Duplex setting of the port. Is it possible? If it's possible then please help me with the correct Radius Return Attribute.
I don't think there is a common radius attribute to set duplex on an interface, you should look into the auto smart port feature, which allows you to create switchport configuration macro on the switch, where you can set duplex settings, and you can then tell the switch to run the name of that macro with a cisco radius attribute as a result of 802.1x authentication.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...