RADIUS/TACACS+ not responding even on the same vlan
Have anyone encountered this problem before? My radius is at 192.168.1.10 and R1 is on 192.168.1.1. Both are connected to a switch and ping works perfect. ACS has been configured with R1 as the AAA client with a key. I'm baffled as to why this does not work. I've even changed the authentication to TACACS+ and still the same problem occurs.
R1#test aaa group radius cisco cisco legacy
Attempting authentication test to server-group radius using radius
No authoritative response from any server.
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 192.168.1.10, timeout is 2 seconds:
Success rate is 100 percent (5/5), round-trip min/avg/max = 1/1/4 ms
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...